Crystal LAN (tm) Family Ethernet Adapter - NDIS 3.0 Windows NT Device Driver
Copyright (c) 1996 Crystal Semiconductor Corporation, All Rights Reserved
===============================================================================


Installation Notes for Installing the NDIS 3.0 Driver for Windows NT

1.  Boot Windows NT and log on as Administrator or as a user with
    Administrator's privileges.

2.  After Windows NT has finished booting, open the "Main" window from the
    Program Manager.

3.  Open the "Control Panel" window and double-click on the "Network" icon in
    the Control Panel window.

4.  If the message: "Windows NT Networking is not installed.  Install it now?"
    is displayed, reply "Yes", otherwise continue with step 5.

    When prompted, choose "Do Not Detect" network adapter and then "Continue".
    Continue the installation with step 6.

5.  Continue with the "Network Settings" dialog by clicking the "Add Adapter"
    button.

6.  From the "Add Network Adapter" dialog, click the down arrow on the "Network
    Adapter Card" list box.  Select "<Other> Requires disk from manufacturer"
    at the end of the adapter list.   Click the "Continue" button.

7.  When prompted, insert the Crystal LAN driver diskette in drive A: and click
    on "OK" to accept the default path of A:\.

8.  Select "Crystal LAN(tm) Family Ethernet Adapter" and click on "OK".

9.  If you will be installing an additional Crystal LAN(tm) Ethernet option
    board (or other CS8920-based adapter) in the same PC, enter the serial
    number of the adapter for which you are now installing the driver.
    Otherwise, you may leave this field blank. Click on the "Continue" button
    when finished.

10. If you want to override the adapter's assigned Ethernet Address, enter
    the 12 hex-digit locally administered address in the "NetworkAddr" field.
    Otherwise, leave this field blank.  Click on "Continue" when finished.

    Note: Only assign a local Ethernet Address in accordance with IEEE 802.2
    specifications.  A universally administered Ethernet Address is assigned
    at the factory and is used by default.

11. Select the transmission mode you want the adapter to use.  It is strongly
    recommended you use the default "Auto Negotiate" for the Crystal LAN
    adapter unless you are sure of the transmission mode capabilities of the
    network equipment to which you will be connecting.

    WARNING: Setting a transmission mode that is incompatible with the other
    equipment on your network will prevent the adapter from working properly
    and can adversely affect your entire network's performance.

12. The next step is to select the appropriate protocols to bind to the
    adapter for your network environment.  When prompted, install the protocol
    options and utilities required for your network.  (If not prompted,
    use the "Add Software" and then the "Bindings" option from the "Network
    Settings" dialog.)

13. Restart Windows NT when prompted for all changes to take effect.