The IRSERIAL DRIVER DISK and IrDA DRIVER DISK contain the 
drivers necessary to use an IrDA protocol stack for infrared 
communication on an HP OmniBook 4000, running Windows 95.

Requirements:
- HP OmniBook 4000 with BIOS 4.10*
- Windows 95, installed 
- IRSERIAL DRIVER DISK (Echo Cancelling Serial Driver for OB4000)
- IrDA DRIVER DISK

You must remove any previously installed Win95 IrDA drivers. 
This should be done by running the 'Add/Remove Programs' option
in the Control Panel.  Highlight the 'Infrared Support for Windows 95 
Version...' option in the list and press the 'Add/Remove' button.
Windows 95 will remove the drivers.

Use the following steps to install IrDA support:

1. Insert the IRSERIAL DRIVER DISK in Drive A: of the OB4000
2. Follow the directions in the INSTALL.TXT file located 
   on the IRSERIAL DRIVER DISK.
3. Insert the IrDA DRIVER DISK into drive A: of your OB4000
4. From the Win95 Start menu, select 'Run' and enter A:\SETUP.EXE

The installation wizard will guide you through the rest
of the setup.

--------------------------------------------------------------------

* The BIOS 4.10 upgrade filename is upg4bios.exe and can 
be downloaded from: 
- http://www.hp.com/go/cposupport  
- ftp://ftp.hp.com/pub/mobile_computing
- Compuserve:  GO HPPC
- America On-Line

**Warning
- During installation, you should see LPT3 and COM4 defined
as virtual IrDA ports.  If you see LPT4 and COM5, it is 
likely a previous IrDA installation still exists.  Cancel the 
installation process and follow the directions above for removing 
any previously installed Win95 IrDA drivers.  Begin the IrDA 
driver installation process again.

- The version of LapLink Remote installed on the OB4000 is
not IrDA compliant.  It can not be run at the same time 
as IrMonitor.