README.TXT File README file for TDK MusicCard (C) Copyright TDK Corp. 1996 This document, the following supplementary information about TDK MusicCard has been described. We encourage you to read them carefully. ************************************************** **************************** Notes [1] During the installation Attention at the time of insertion [2] Card Change of [3] CONFIG.SYS Avoidance of conflict [4] I / O IRQ About the configuration files of [5] MIDI mapper Change of [6] SYSTEM.INI If the driver compatibility [7] Windows Sound System Ver2.0 is already incorporated into the Notes on using [8] WAVE Config [9] for the "Advanced Settings" For [10] polyphony ************************************************** **************************** Notes [1] During the installation Before you install, service socket / Kadosa to your existing system Please check whether the service is installed. Is usually incorporated into the system The look has been incorporated in some models may need to be installed. Attention at the time of insertion [2] Card Card insertion and removal in Windows, such as a hard disk as possible-free access Well, please make sure that state the program halt state. In addition, the removal / insertion of the card is a bit Please spaced at intervals of several seconds without. If the card was removed during playback / WAVE during music playback, if the system is stopped Please avoid if possible they may. Change of [3] CONFIG.SYS TDK MusicCard installer, Card Services client DOS level drivers of Add to the end of the CONFIG.SYS (TDKMC.SYS) driver. Multi-configuration and parts If you are using, Soke of your existing system in the editor switching system port ? Please add after the line of Ttosabisu registration / card service. Format details, please refer to [4]. Avoidance of conflict [4] I / O IRQ TDK Musi I / O was observed TDKMC.SYS is made available by the card service, the IRQ The reserve for cCard. To the rest of the system resources of your existing card service If you are not aware about, assign I / O for use with other TDK MusicCard, the IRQ You may be assigned, the operation becomes unstable. Capital available to the card service Source setting, please refer to the help of card services for the system, etc. on hand The stomach. In addition, the utility that comes with some PC card, card resources at the time of removal May not open completely done. In this case, the registration of CONFIG.SYS TDKMC.SYS Specify the I / O TDK MusicCard line parameters to use in the proceedings, the IRQ, other mosquito Please avoid I / O ? soil to be used, and IRQ. [Format] DEVICE [HIGH] = (path) TDKMC.SYS [/ IO1 = xxx / IO2 = xxx / IRQ = x] / I / O IO1 = xxx ... MIDI synthesizer that is used (200 ~ 2F0) / I / O for use with IO2 = xxx ... MIDI port (300 ~ 3F0) / IRQ = x ... IRQ No. (0 ~ F) * Please describe when you specify a numeric value of exactly three * If the I / O · IRQ you specify has been reserved on the card service , Search for other resources. [Setting example] DEVICE = C: \ TDKDOS \ TDKMC.SYS / IO1 = 250 / IO2 = 310 / IRQ = A About the configuration files of [5] MIDI mapper TDK MusicCard installer, use the sound card of other customers already If, then save it as a MIDIMAP.CFG MIDIMAP.TD_ file. If you would like to use the MIDI map of the original, while for the TDK MusicCard in the next step Please create a steps. *********************************** MIDIMAP.TD_ MIDIMA the directory of a file on your system. Windows To copy P.CFG. * Note: Please perform this operation on DOS. In addition, TDK MusicCard Instruments An alias name that you save the installer file that was created MIDIMAP.CFG It is recommended. To start the 2. Windows Start the "Control Panel" of the "main" group of three. Program Manager To. To start the 4. MIDI mapper. To create a new map in the "New" button. 5. TDK MusicCard SYNTH: name Such as TDK MusicCard GM Synthesizer: commentary Each port 6. TDK MusicCard MIDI SYNTH (or built-in synthesizer) Assign (MIDI external port) TDK MusicCard MIDI OUT. Patch and maps do not need to change the channel in particular. To save the new settings. 6. *********************************** Available in standard MIDI file (. MID) is a book of personal computer communication in general, etc. There is one corresponding to the Basic GM Extend GM and set in the file set. Corresponding to each set of 11 to 16 channels 1 ~ 10 channels in this case Data has been entered. If this song, channel 16 is also the rhythm section Because it is assigned, to disable the channel 16 in the MIDI mapper You may hear a beautiful song by. Change of [6] SYSTEM.INI TDK MusicCard installer, the WAVE / MIDI / AUX other driver in SYSTEM.INI Comment it out. Can be used simultaneously with other sound cards, if necessary Is. In that case, midi =, midi1 =, midi2 =, please put a No. To device ... etc. The stomach. [: System.ini case] . . . [Drivers] timer = timer.drv midimapper = midimap.drv ; Midi = xxxxxxx.drv | ; Wave = xxxxxxx.drv | driver <--- the installer has been commented out ; Aux = xxxxxxx.drv | midi = tdkmusic.drv | driver <--- the installer has been added | wave = tdkmusic.drv aux = tdkmusic.drv | . . . Change the following manner of concurrent use and if the other cards. . . . [Drivers] timer = timer.drv midimapper = midimap.drv midi = xxxxxxx.drv | ; Wave = xxxxxxx.drv | driver <--- the installer has been commented out ; Aux = xxxxxxx.drv | midi1 = tdkmusic.drv | driver <--- the installer has been added | wave = tdkmusic.drv aux = tdkmusic.drv | . . . If the driver compatibility [7] Windows Sound System Ver2.0 is already incorporated into the TDK MusicCard driver to the mixer API of Windows Sound System Ver2.0 Supports. If "MSMIXMGR.DLL" to your existing system has been built, [drivers] security By adding a mixer = to action, only the corresponding Windows Sound System Ver2.0 TDK MusicCard mixer volume controls for driver applications Is possible. [: System.ini case] . . [Boot] . . confirm drivers = mmsystem.dll msmixmgr.dll <---- . . [Drivers] timer = timer.drv midimapper = midimap.drv midi = tdkmusic.drv wave = tdkmusic.drv aux = tdkmusic.drv Add mixer = tdkmusic.drv <----- * Note: If there are only compatible driver mixer of Windows Sound System Ver2.0, An error may occur. Dry-compatible Windows Sound System Ver2.0 You can use the server at the same time as the WAVE drivers, drivers incorporate TDK MusicCard You may be able to work around that. [Drivers] timer = timer.drv midimapper = midimap.drv If you're still only in this way mixer - mixer = xxxx.drv < ; Wave = xxxx.drv error occurs midi = tdkmusic.drv wave = tdkmusic.drv aux = tdkmusic.drv [Example Fix] ; Mixer = xxxx.drv <- remove the mixer xxxx.drv ; Wave = xxxx.drv midi = tdkmusic.drv wave = tdkmusic.drv aux = tdkmusic.drv [Example Fix] mixer = xxxx.drv using the WAVE of xxxx.drv - wave = xxxx.drv < midi = tdkmusic.drv wave1 = tdkmusic.drv aux = tdkmusic.drv [Example Fix] mixer = xxxx.drv ; Wave = xxxx.drv midi = tdkmusic.drv wave1 = tdkmusic.drv aux = tdkmusic.drv mixer driver to use the TDK MusicCard - mixer1 = tdkmusic.drv < Notes on using [8] WAVE Config If you select the Playback Method for WAVE, in the "TDK MusicCard Control Panel" Please keep the sound clear all fonts are loaded. Also, please keep to the "Using the WAVE" always in the "Advanced Settings". [9] for the "Advanced Settings" Of "TDK MusicCard Control Panel" in the "advanced", the TDK MusicCard You can prohibit the use of WAVE. "Using the WAVE" if, Musi It uses a few percent of memory in the cCard, large sound font If you do not have to be loaded too, is to "Do not use the WAVE" to set You may be able to load. Also, if you are using a non-driver as a WAVE driver TDK MusicCard Please "do not use the WAVE" in the configuration. For [10] polyphony 32 voice polyphony is possible in TDK MusicCard, usually to make AUX 2 voice Has been for. If you mute the AUX in "TDK MusicCard mixer" is this You can also use to play two MIDI voice. Note: Depending on the tone, because there is something you use a two-voice in a sound, 32 notes simultaneously You may not be able to pronounce. When re-recording of WAVE is to be used for re-recording of about 10 voice WAVE, MIDI playback Number of voices will be available in 20 and about.