TAD-271  (430-0707)          Remote Codes               Faxback Doc. # 6138

Follow these steps to operate the TAD from a remote location:

1.  Dial the phone number.

2.  During the outgoing announcement, press *.  The TAD says, "Enter remote
    code."

Enter the three-digit remote security code you set under "Setting the Time.
Date, and Remote Security Code," making each key press at least 1/2 second
long.  The TAD sounds a short beep at each entry.

If you do not enter the code within 7 seconds, or if you enter an incorrect
code, the TAD gives an error announcement ("First error," "Second error,"
and "Third error.")  After the third error, the TAD completes the outgoing
announcement and records your call as an incoming message (if INCOMING
MESSAGE is not set to ANN ONLY).

If the code is correct, the TAD tells you the current call and message
count and then plays any new messages.  At the end of each message, the
TAD announces the number, time, day, and date of the message.  At the end
of the messages, the TAD says, "End of messages.  Enter command or star for
help."  Enter the command or hang up to end remote operation.

The TAD says, Enter command" after each operation.  If you do not enter a
command within 7 seconds, a beep sounds and the TAD says "End of calls" and
hangs up.

REMOTE CONTROL FUNCTIONS

The following sections describes the remote control functions for each key
on a touch-tone phone's keypad.

(1)  Rewind/Backspace

   Press 1 to rewind the tape.  The TAD says, "Rewind" if the tape is not
   at the beginning.  The tape stops rewinding at the beginning of the new
   message group or the beginning of the tape.  See "Replaying Messages."

If you press 1 during playback, the tape rewinds for a few seconds, and
then begins playback.

(2)  Play

   Press 2 to play the incoming message tape, beginning at its current
   position.  Playback automatically stops at the end of the messages.

(3)  Fast-forward

   Press 3 to fast-forward the incoming message tape.  Fast-forwarding
   automatically stops at the end of the messages.

(4)  Record memo

   Press 4 to record a memo.  After you hear the beep, speak into the
   handset.  After 30 seconds, recording automatically stops and a beep
   sounds.  To stop recording sooner, press *.

(5)  Play announcement

   Press 5 to play the outgoing announcement.

(6)  Record announcement

   Press 6 to record a new outgoing announcement.  After you hear the beep,
   speak into the handset.  Press * to stop recording.

(7)  Beginning of new messages

   press 7 to move the tape to the beginning of the new messages.

(8)  Room monitor

   Press 8 to monitor the room where the TAD is located.  After 30 seconds,
   monitoring automatically stops and a beep sounds.  To stop monitoring
   sooner, press *.

(9)  End of new messages

   Press 9 to move the tape to the end of the new messages.

(0)  Answer on/off

   Press 0 to set the TAD to not answer calls (answer-off) or to return
   it to answer calls (answer-on).

(*)  Stop (or remote control command menu from stop mode)

   Press * to stop the current function.  Or, when the TAD is not
   performing a command, press * to hear the list of remote commands.

(RLR-02-23-94)