SENSATION!  (250-1651)     Installing the Software     Faxback Doc. # 2865

Installing the Operating System and Software

Following are the steps to install the DOS and the Sensation's software.

1.  Place the Startup floppy disk in drive A: and boot the computer.

    The Startup floppy disk is supplied with the Sensation.

2.  At the A:> type FORMAT C: /S /U <Enter>

    The /S will make the hard drive bootable.
    The /U (unconditional) will format without saving a mirror file.

3.  Place the SYSTEM CD in the CD-ROM drive.
    At the A:> type SETUPDOS <Enter>

    This will install the DOS to the hard drive.

4.  Remove Startup floppy disk from drive A: and reboot computer.

5.  At C:\>, remove the SYSTEM CD from the CD-ROM drive.  Place the DATA CD
    in the CD-ROM drive.

6.  Type D: <Enter> to get a D:\> prompt.

7.  From the D:\> prompt, type INSTALL <Enter>

8.  Select OPTION 1 from the menu.

    Option 1 will install the software as it was from the factory.

    You will see a message saying that the installation takes about 20
    minutes.

9.  When installation is complete, reboot computer.

    The computer should boot to the opening demo screen.

Note:  If DoubleSpace has been installed, step 2 should be:

       2.  From the A: prompt, type FDISK <Enter>

	   First delete DOS partition, then re-create DOS partition.
	   Exit FDISK and reboot with the Startup floppy.

       Proceed with the remaining steps, with FORMAT being step 3, etc.

(sm/rl-9/15/94)